Check out the information Codes On a Samsung oven
In most cases, the displayed information codes are not a malfunction and can be cleared with a reset. Check the codes and instructions below and try the suggestions. However, some information codes need additional steps to be cleared. If any codes keep appearing on the screen, contact a Samsung service center for further support.
Frequently displayed information codes and solutions
|
Code |
Meaning |
Solutions |
|---|---|---|
|
C-d0 |
Button problem This displays when a button is pressed and held for a period of time. |
Clean the buttons and make sure there is no water on/around them. Turn off the oven and try again. |
|
S-01 |
Safety shutoff Oven has continued operating at a set temperature for an extended time period.
|
This is not a system failure. Turn off the oven and remove the food. Then try again normally. |
|
dC dE |
Divider check needed If the divider is removed during cooking in Dual cook mode. If the divider is inserted during cooking in Single cook mode. |
The divider must not be removed during cooking in Dual cook mode. Turn off the oven and then restart. If the problem continues, turn off the power for 30 seconds or more and then reconnect. |
|
C-d1 |
Door lock malfunctions |
Turn off the oven and then restart. If the problem continues, turn off the power for 30 seconds or more and then reconnect. |
|
C-20 C-21 C-22 |
Sensor malfunctions |
Turn off the oven and then restart. If the problem continues, turn off the power for 30 seconds or more and then reconnect. |
Note:
- If you find an information code that is not listed on this page, please find a manual with the specific model number.
- It may have a different design and information code depending on the model.
- If you are unable to clear any code from your oven, please contact the Samsung service center for further support.
Additional information codes
|
Code |
Meaning |
Solutions |
|---|---|---|
|
C-F1 |
Only occurs during EEPROM Read/Write. |
Turn off the oven and then restart. If the problem continues, turn off the power for 30 seconds or more and then reconnect. |
|
C-F0 |
If there is no communication between the main PCB and sub PCB. |
Turn off the oven and then restart. If the problem continues, turn off the power for 30 seconds or more and then reconnect. |
|
C-F2 |
Occurs when a communication problem is maintained between the Touch IC and Main or Sub micom. |
Turn off the oven and then restart. If the problem continues, turn off the power for 30 seconds or more and then reconnect. |
|
Pr E |
This code means the oven is preheating. |
Pr E will display until the temperature is reached at the setting temperature. When the temperature reaches at the desired temperature, Pr E will disappear. While preheating, please keep the door closed. |
Note:
- If you find an information code that is not listed on this page, please find a manual with the specific model number.
- It may have a different information code depending on the model.
- If you are unable to clear any code from your oven, please contact the Samsung service center for further support.
This code appears when you select the Grill function and set the temperature between 50°C and 250°C, or if you select Normal Cooking mode and set the temperature between Grill 1 and 3, you are asked to reset the temperature with a message and a beep.
Note:
- It may have a different design and information code depending on the model.
- If you are unable to clear any code from your oven, please contact the Samsung service center for further support.
Thank you for your feedback!
Please answer all questions.
Samsung Members
![]()
![]()
Call Us
9am to 6pm daily
Repair Services
![]()
![]()
RC01_Static Content